MediaWiki:Sitenotice:
2024-03-02: The wiki ran out of disk space, so things were not working. This has been resolved by adding another 5GB of quota ;-) Thanks to Tim Lindner for reporting the issues.
2020-05-17: If a page gives you an error about some revision not being found, just EDIT the page and the old page should appear in the editor. If it does, just SAVE that and the page should be restored. OS-9 Al (talk) 12:22, 17 May 2020 (CDT)
EPROM Programming: Difference between revisions
No edit summary |
m (MagicFab moved page EPROM Programmer to EPROM Programming: Re-write) |
(No difference)
| |
Revision as of 00:52, 4 September 2022
I don't know how many versions were made, but mine runs off a single +5 volt supply. It does not use batteries to get the programming voltage, it uses a DC-to-DC voltage contverter to generate the +12V, +21V, or +25V programming voltage. By using a DC-to-DC converter, it allows it to work on all versions of the coco. This IS compatable with the CoCo3.
repair tip: I had my DC-to-DC converter go bad (I broke it, by overloading it, it was an accident), and I simply tested the 4 transistors and replaced the bad one(s). With the price of these small signal transistors, you're probably better off to just replace all of them.
I will try to get a picture of mine posted before too long. Someone contact me if I forget.